Changing The Cable Stand; Changing The Inlet Valve - Asko 600 Series Service Manual

SERVICE

Changing the cable stand

1. Remove the top cover by first removing the 3
screws at the rear edge and then lifting the cover
off.
2. Remove the wiring.
3. Route the new wiring and secure it.
IMPORTANT
Make sure that the wires are connected correctly.
4. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.

Changing the inlet valve

1. Remove the top cover by first removing the 3
screws at the rear edge and then lifting the cover
off.
2. Disconnect the water supply connection from
the inlet valve.
3. Remove the 2 screws under the cross member
and lift up the valve.
4. Remove the hoses and wiring.
5. Install the wiring in accordance with the elec-
trical schematic diagram and secure the hoses.
6. Install the inlet valve in the cross member and
secure it with the 2 screws.
IMPORTANT
The wiring to the lid catch must run between the
inlet valve and the cross member.
7. Install the water supply connection.
8. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.
68
2
3
2
4