Removing The Panel; Installing The Panel - Asko 600 Series Service Manual

SERVICE
PANEL

Removing the panel

1. Remove the top cover by first removing the 3
screws along the rear edge and then lifting it
off.
2. Pull forward and lift out the detergent insert.
NOTE
The detergent insert may have a child safety catch
fitted. To pull out the detergent insert when the
safety catch is set, you have to move the latch to
the left at the same time as you pull out the tray.
3. Remove the 2 screws for the detergent
compartment in the panel and 1 above the
compartment. Move the detergent compart-
ment to one side.
4. W600 and W620: Remove the knob.
IMPORTANT
Turn the knob to its zero position before taking
it off, to simplify refitting.
NOTE
It is possible to use a polygrip (mole wrench) to
remove the knobs, but in that case remember to
put some soft material in the jaws so as not to
scratch the plastic.
5. Remove the 4 fasteners behind the panel by
bending the clips open with a broad-bladed
screwdriver (6.5 to 7 mm) and lifting off the
panel.
IMPORTANT
Be careful not to break the fasteners.

Installing the panel

6. Offer up the panel at the top edge and press it
into place at the bottom edge.
IMPORTANT
Don't forget to put the indicator lamp back.
26
5
3
3
2
4