Transport Supports; Removing The Transport Support - Asko 600 Series Service Manual

INSTALLATION
INSTALLATION

TRANSPORT SUPPORTS

Before the machine can be used, the 3 transport
supports must be removed. Each transport sup-
port consists of a screw, a washer and a transport
sleeve. The transport sleeves are used after the sup-
ports have been removed, to plug the holes in the
transport beam.

Removing the transport support

1. Undo the screw and remove the washer.
2. Remove the transport sleeve by first raising it
up and than taking it out.
3. Fit the transport sleeves into the transport sup-
port holes.
IMPORTANT
Keep the screws and washers in a safe place, in
case the machine has to be transported again later
on.
6
3
2
1