Removing The Drum; Installing The Drum - Asko 600 Series Service Manual

SERVICE
DRUM

Removing the drum

1. Remove the end plate and inner cover plate at
the front in accordance with the section
end plate holder... - Removing...".
2. Remove the rear panel by first removing the
12 screws around it and then lifting it off.
3. Take off the drive belt by lifting it off one
side of the pulley and turning the pulley.
4. Remove the pulley screw and remove the pul-
ley and the wavy washer.
5. Pull out the drum.

Installing the drum

6. Install an O-ring on the drum shaft
7. Install the drum.
8. Install the wavy washer on the drum shaft.
WARNING
A missing wavy washer can lead to leakage, drum
shaft failure and bearing failure.
9. Install the pulley and tighten the screw.
10. Install the drive belt in the reverse order. Start
by putting the belt under the motor pulley.
IMPORTANT
Take care that the drive belt lies centred on the
top edge of the pulley. Turn the pulley to check
this.
11. Install the rear panel by hanging it on the 2
hooks on the top edge and then securing its
edges with the 12 screws.
12. Refit the end plate and inner cover plate in
accordance with the section
te... - Installing".
50
3
"Front
4
6
"Front end pla-
5