Removing The Washing Lid; Installing The Washing Lid; Changing The Lid Seal/Glass - Asko 600 Series Service Manual

WASHING LID

Removing the washing lid

1. Open the washing lid either by pressing the
lid opening button or with the emergency
opening handle behind the drain pump co-
ver.
2. Remove the 2 screws securing the lid and take
it off.

Installing the washing lid

3. Hook on the lid.
4. Secure the lid with the 2 screws.

Changing the lid seal/glass

1. Open the washing lid either by pressing the
lid opening button or with the emergency
opening handle behind the drain pump co-
ver.
2. Remove the 2 screws securing the lid and take
it off.
3. Remove the four screws around the glass.
4. Take off the frame by inserting a screwdriver
into the opening of the underside of the lid
and turning it.
5. Remove the glass.
6. Changing the seal: Pull off the seal and press a
new one on.
7. Install 2 of the fixings.
8. Slide the glass in under the fixings.
9. Install the other 2 fixings. Partly tighten the
screws.
10. Install the frame, starting at the rear edge, and
press it in.
11. Finally tighten the 4 screws fully.
12. Install the washing lid.
2
2
3
6
SERVICE
4
7
43