Removing Drain Pump And Pump Housing; Installing The Drain Pump And Pump Housing - Asko 600 Series Service Manual

SERVICE
DRAIN PUMP

Removing drain pump and pump housing

1. Models with front loading door: Remove the
bottom cover in accordance with the section
"Bottom cover (models with front loading
door) - Removing...".
Models without front loading door: Remove
the front panel in accordance with the section
"Front panel (models without front loading
door) - Removing...".
2. Remove the pump and pump housing from
the rubber fixings in the bottom plate.
3. Release the 3 hose clips and remove the hoses.
Also remove the hose clip for the drain hose
and remove this.
4. Disconnect the terminal block.
5. Detach the emergency opening cord.

Installing the drain pump and pump housing

6. Secure the emergency opening cord.
IMPORTANT
It is important for the emergency opening cord
to be securely fastened to the pump housing and
that the cord is free from obstructions.
7. Secure the terminal block.
8. Connect the 3 hoses and secure them with
hose clips. Also connect the drain hose and
secure it with a hose clip.
9. Secure the pump housing to the fixings on
the bottom plate.
10. Models with front loading door: Install the
bottom cover in accordance with the section
"Bottom cover (models with front loading
door) - Installing...".
Models without front loading door: Install
the front panel in accordance with the section
"Front panel (models without front loading
door) - Installing...".
52
3
2
3