Asko 600 Series Service Manual page 47

10. Install the front end plate and tension the spe-
cial tool's two lower parts to it.
IMPORTANT
It is important for the front plate to be located in
the groove in the holder panel.
NOTE
Use the special tool's upper fixing to hang the
end plate on.
11. Install the tensioning ring by turning it to the
right place and then securing the screw.
IMPORTANT
Be sure that the tensioning ring is properly loca-
ted over the edges of the end plate.
12. Tighten the screw fully.
13. Use a rubber mallet to knock the tensioning
ring into place on the upper edge and sides.
Also move it to the edge of the end plate with
pliers.
14. Tightly secure the tensioning ring.
15. Remove the lower hook.
16. Hook the balancing spring to the top side of
the holder.
17. Remove the special tool.
18. Refit the protection and catch in accordance
with the section "Catch - Installing...".
10
11
10
SERVICE
49