SERVICE
Changing the bearing
1. Remove the drum in accordance with the sec-
tion
"Drum - Removing...".
2. Remove the v-ring cassette with a screwdri-
ver.
3. Knock out both bearings.
NOTE
Discard the bearings after removal.
4 Place the inner bearing on the special tool (part
no. 88 011 53) and put it inside the holder.
IMPORTANT
Position the special tool support between the hea-
ting element loops.
5 Put the outer bearing and washer on to the
tool, at the rear of the bearing housing.
6. Tighten the nut.
7. Insert the bearing into place with the special
tool.
8. Remove the nut and remove the special tool.
9. Install the drum in accordance with the sec-
tion
"Drum - Installing...".
56
2,3
5,6