Changing The Push-Button Switches; Changing The Knobs (W600 And W620) - Asko 600 Series Service Manual

SERVICE

Changing the push-button switches

1. Remove the panel in accordance with the sec-
tion "Panel - removing...".
2. Get hold of the switch inside the machine and
pull on it, while at the same time bending the
wings at the front of the switch inwards with
a screwdriver.
IMPORTANT
Don't pull on the wires. The button might come
apart.
3. Press in the new push-button and check that
the wings open out.
IMPORTANT
Connect the wires to the correct connector pins.
4. Install the panel in accordance with the sec-
tion "Panel - Installing...".

Changing the knobs (W600 and W620)

1. Remove the knobs by pulling them off.
IMPORTANT
Turn knobs to their zero positions before taking
them off, to simplify refitting.
NOTE
It is possible to use a polygrip (mole wrench) to
remove the knobs, but in that case remember to
put some soft material in the jaws so as not to
scratch the plastic.
2. Install the new knob.
28
2
2
1