Table of Contents
Advertisement
Installation
Drainage connection
The machine is supplied with a drainage hose
attached, which must be connected to a drain.
See the examples below. The height must be
600-900 mm above fl oor level.
The lower position (600 mm) is always
preferable. Ensure that the drainage hose has
no kinks.
600--900 mm
The machine can also be connected to the drain
via a spigot connection. In this case the hose
should also be 600-900 mm above the fl oor. The
internal diameter of the hole should be at least
18 mm.
• Cut the nipple
• Remove burrs from the hole.
See the illustration.
At least 18 mm
Electrical installation
If the machine is delivered from the factory
with a plug attached, it can be connected to an
earthed wall socket. Otherwise, a permanent
connection using a multipolar circuit breaker
must be made by a qualifi ed professional.
Connection on delivery
The machine is supplied as 1-Phase, 230V,
50Hz, heat output 2000W and has a 16A plug.
Any residual current devices must be type A.
NOTE!
Repairs and maintenance relating to safety or
performance must be carried out by a qualifi ed
professional.
27
Advertisement
Table of Contents
