Changing The Level Switch; Changing The Level Sensor - Asko 600 Series Service Manual

SERVICE

Changing the level switch

1. Remove the top cover by first removing the 3
screws at the rear edge and then lifting the cover
off.
2. Squeeze the level switch securing clips, if ne-
cessary with pliers, and remove it from the
bridge piece.
3. Remove the wiring and connector pins.
4. Remove the rubber hose from the underside.
5. Put the rubber hose on to the new level switch.
6. Connect the wiring and connector pins.
7. Insert and push the level switch to secure it
on the bridge piece.
8. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.

Changing the level sensor

1. Remove the top cover by first removing the 3
screws at the rear edge and then lifting the cover
off.
2. Squeeze the level sensor securing clips, if ne-
cessary with pliers, and remove it from the
bridge piece.
3. Remove the connector pins.
4. Remove the rubber hose from the underside.
5. Put the rubber hose on to the new level sen-
sor.
6. Reconnect the terminal block.
7. Insert and push the level sensor to secure it on
the bridge piece.
8. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.
62
2
2