Changing The Shock Absorbers - Asko 600 Series Service Manual

SERVICE

Changing the shock absorbers

1. Front shock absorbers: Remove the front pa-
nel in accordance with the section
nel (models without front loading door) -
Removing..." or else the bottom cover in ac-
cordance with the section
Removing...".
Rear shock absorbers: Remove the rear pa-
nel by first removing the 12 screws around it
and then lifting it off.
2. Remove the shock absorber nuts under the
bottom plate.
3. Support the holder from underneath or secu-
re it with a hook from above.
4. Compress the shock absorber. Angle it out-
wards and pull it off downwards.
5. Take off the piston rods.
6. Remove the rubber bushes.
7. Install new rubber bushes, piston rods and
shock absorbers.
8. Compress the shock absorber and put it into
position in the bottom plate.
9. Fit the nut on the underside and tighten it.
10. Front shock absorbers: Install the front pa-
nel in accordance with the section
nel (models without front loading door) - In-
stalling..." or else the bottom cover in accor-
dance with the section
stalling...".
Install the rear panel by hanging it on the 2
hooks on the top edge and then securing its
edges with the 12 screws.
72
"Front pa-
"Bottom cover -
"Front pa-
"Bottom cover - In-
4