Changing The Input Terminal Block - Asko 600 Series Service Manual

CROSS MEMBER

Changing the input terminal block

1. Remove the top cover by first removing the 3
screws at the rear edge and then lifting the cover
off.
2. Remove the earthing screw.
3. Disconnect all the wiring.
4. Press the latches in with a screwdriver and pull
out the input terminal block.
NOTE
Make sure that the wires are connected correctly
when changing the input terminal block and the
connection cables.
5. Install the new input terminal block, the lat-
ches must clip on to the edge of the plate.
6. Install the wiring in accordance with the elec-
trical schematic diagram.
7. Secure the earthing screw.
IMPORTANT
Don't forget to put the earthing screw back.
8. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.
4
SERVICE
2
65