Changing The Hinge Bearing - Asko 600 Series Service Manual

SERVICE
FRONT PANEL (MODELS WITH FRONT LOADING
DOOR)
Removing the front panel
1. Remove front loading door in accordance with
the section "Front loading door - Remo-
ving...".
2. Pull forward and lift out the detergent
compartment.
NOTE
The detergent compartment may have a child sa-
fety catch fitted. To pull out the detergent
compartment when the safety catch is set, you
have to move the latch to the left at the same
time as you pull out the tray.
3. Remove the lower right hand screw from the
panel and then remove the panel in accordan-
ce with the section "Panel - Removing...".
4. Remove the 2 screws behind the rubber dam-
pers and the 2 screws beneath.
5. Remove the front panel.
Installing the front panel
6. Offer up the panel and secure it with the 2
screws at the bottom and the 2 at the top.
Refit the rubber dampers.
7. Install the panel in accordance with the sec-
tion "Panel - Installing...".
8. Secure the panel screws.
9. Install the front loading door in accordance
with the section "Front loading door - Instal-
ling...".

Changing the hinge bearing

1. Remove the front panel in accordance with
the section "Front panel (models with front
loading door) - Removing...".
2. Remove the hinge bearing by pushing the lat-
ches at the rear inwards with the aid of a screw-
driver.
3. Carefully remove the bearing.
4. Install a new bearing by putting it into place
and pressing it in.
5. Refit the front panel in accordance with the
section "Front panel (models with front loa-
ding door) - Installing...".
40
3
2
4
4