Changing The Tensioning Ring - Asko 600 Series Service Manual

Changing the tensioning ring

1. Remove the cover plate in accordance with
the section "Cover plate -
2. Install the special tools (part no. 88 011 52
and ).
IMPORTANT
Fasten the special tool's 3 fixings in the drum end.
3. Slacken the tensioning ring and remove it.
IMPORTANT
Do not lever the tensioning ring off. Undo one
end and turn it round the holder to remove it.
4. Install the new tensioning ring by turning it
to the right place and then securing the screw.
5. Tighten the screw fully. Use a rubber mallet
to knock the tensioning ring into place on the
upper edge. Also move it to the edge of the
end plate with pliers.
6. Tighten the tensioning ring more.
7. Remove the special tool.
8. Refit the cover plate in accordance with the
section "Cover plate - Installing...".
Removing...".
2
2
3
2
SERVICE
59