Removing The Catch; Installing The Catch - Asko 600 Series Service Manual

CATCH

Removing the catch

1. Remove the cover plate in accordance with
the section "Cover plate - Removing..."
2. Release the protection.
3. Disconnect the wires from the catch.
4. Remove the lid catch screws.
5. Pull out the catch.
6. Remove the emergency opening cord.

Installing the catch

7. Make a loop in the emergency opening cord
and hang it on the hook. Pull the loop.
8. Put the latch back and secure it.
9. Reconnect the wiring to the latch.
10. Refit the protection.
IMPORTANT
Make sure the emergency opening cord does not
get trapped between the protection and the hol-
der.
11. Refit the cover plate in accordance with the
section "Cover plate - Installing...".
7
5
6
3
SERVICE
4
47