Changing The Drain Pump Rubber Ring; Changing The Rinse Sensor (W660) - Asko 600 Series Service Manual

SERVICE

Changing the drain pump rubber ring

1. Open the drain pump cover. Use the parti-
tion from the detergent compartment or a
screwdriver.
2. Disconnect the drain hose.
IMPORTANT
Take care not to break off the drain plug.
NOTE
There may be water left in the machine, that will
run out through the drain hose.
3. Remove the screw to detach the emergency
opening handle.
4. Pull the rubber ring from the pump housing.
5. Put the new ring on to the pump housing.
IMPORTANT
The tab on the ring must be upwards and in line
with the tab on the pump housing.
6. Secure the emergency opening handle with the
screw and refit the drain hose.
7. Close the cover.

Changing the rinse sensor (W660)

1. Models with front loading door: Remove
the bottom cover in accordance with the sec-
tion "Bottom cover (models with front loa-
ding door) - Removing...".
Models without front loading door: Rem-
ove the front panel in accordance with the sec-
tion "Front panel (models without front loa-
ding door) - Removing...".
2. Remove the 2 hose clips that hold the sensor
and remove the sensor from the hose.
3. Disconnect the terminal block.
4. Insert the terminal block into the socket on
the new sensor.
5. Thread the hose clips along the 2 water hoses
and secure them to the sensor.
6. Models with front loading door: Install the
bottom cover in accordance with the section
"Bottom cover (models with front loading
door) - Installing...".
Models without front loading door: Install
the front panel in accordance with the section
"Front panel (models without front loading
door) - Installing...".
54
2
4
2
3