Hot Water Connection; Installation Of Hot Water Connection - Asko 600 Series Service Manual

MODIFICATION OF W600 AND W620

HOT WATER CONNECTION

These machines can be modified to include a hot
water connection and thus use a mixed water in-
let.

Installation of hot water connection

1. Remove the 3 screws at the rear edge of the
top lid and lift off the lid.
2. Knock out the plug in the cross-member.
3. Fit a 1-way hot water valve into the hole and
connect the hot water piping to it.
4. Install a hose between the inlet valve and the
free connecting flange on the detergent con-
tainer.
IMPORTANT
Knock out the plug in the flange on the deter-
gent container.
5. Fit an electrical jumper between the new inlet
valve and the 3-way valve, see the electrical
schematic diagram.
6. Install a new wire from IV3 on the inlet valve
to the programmer header connector E4-4,
see the electrical schematic diagram.
7. Cut the jumpers J-C and J-E.
8. Refit the top lid.
IMPORTANT
Don't forget the 2 star washers for the top lid
outer screws.
MODIFICATION OF W600 AND W620
75