Chapter 28
Troubleshooting
Sending 5, 100-byte ICMP Echos to 192.9.202.1, timeout is 2 seconds:
. . . . .
Success rate is 100 percent
Troubleshooting SONET Automatic Protection System
For APS line redundancy, the following problems can occur:
•
•
•
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
APS Configuration Problems, page 28-10
Not Able to Correctly Set Up APS 1+1 Line Redundancy Configuration, page 28-10
–
Unable to Set Up APS 1:1 Line Redundancy Configuration, page 28-10
–
Operator Information about APS Architectures, page 28-11
–
Operational Problems, page 28-11
–
What the Various APS Switches Mean
Unable to Perform APS External Switch After Forced or Manual APS Switch, page 28-12
–
APS Manual Switch to a Line Does Not Occur Right Away, page 28-12
–
Switch Occurs After Lockout Issued, page 28-12
–
APS Switch Made to a Line in Alarm, page 28-13
–
Reverse Switch, page 28-13
–
APS Switch Occurs at the Same Time as a Y-Red Switch, page 28-13
–
–
APS Switch Occurs After Issuing an APS Clear Switch, page 28-14
APS Switch Occurs Even Though APS Forced Switch in Effect, page 28-14
–
–
APS Line is Failing to Switch, page 28-14
Large Cell Loss When Performing a Front Card Switchover, page 28-14
–
APS Service Switch Description, page 28-14
–
APS Line Does Not Seem to Switch and Active Line is in Alarm, page 28-15
–
BXM Back Card LED Green and Yellow Indications, page 28-16
–
BXM Port LED States, page 28-16
–
APS Alarms
What Do APS Alarms Represent
–
Troubleshooting SONET Automatic Protection System
Cisco BPX 8600 Series Installation and Configuration
28-9