Class Of Service Templates And Qbins; How Service Class Templates Work - Cisco BPX 8620 Installation And Configuration Manual

Chapter 23 Configuring BXM Virtual Switch Interface
In summary, these are the hot standby operations between active and standby card:
1.
2.
3.
The data transfer from the active card to the standby card should not affect the performance of the active
card. Therefore, the standby card takes most actions and simplifies the operations in the active card. The
standby card drives the data transferring and performs the synchronization. The active card functions just
forward VSI messages and respond to the standby card requests.

Class of Service Templates and Qbins

Class of Service Templates (COS Templates) provide a means of mapping a set of standard connection
protocol parameters to "extended" platform-specific parameters. Full Quality of Service (QoS) implies
that each VC is served through one of a number of Class of Service buffers (Qbins), which are
differentiated by their QoS characteristics.
A Qbin template defines a default configuration for the set of Qbins for a logical interface. When you
assign a template to an interface, the corresponding default Qbin configuration is copied to this
interface's Qbin configuration and becomes the current Qbin configuration for this interface.
Qbin templates deal only with Qbins that are available to VSI partitions, which are 10 through 15. Qbins
10 through 15 are used by VSI on interfaces configured as trunks or ports. The rest of the Qbins are
reserved and configured by Automatic Routing Management.

How Service Class Templates Work

The Service Class templates provide a means of mapping a set of extended parameters, which are
generally platform specific, based on the set of standard ATM parameters passed to the VSI slave during
connection setup.
A set of service templates is stored in each switch (such as BPX) and downloaded to the service modules
(such as BXMs) as needed.
The service templates contains two classes of data:
•
•
The general types of parameters passed from a VSI Master to a Slave include:
•
•
•
•
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
CommBus messages are duplicated to standby slave VSI card by the BCC.
Operation 1 does not need to implement because it had been done by the BCC.
VSI messages (from master VSI controller or other slave VSI card) are forwarded to the standby
slave VSI card by the active slave VSI card.
Operation 2 is normal data transferring, which occurs after both cards are in-sync.
When the standby slave VSI card starts up, it retrieves all VSI messages from the active slave VSI
card and processes these messages.
Operation 3 is initial data transferring, which occurs when the standby card first starts up.
Parameters necessary to establish a connection (that is, per VC), including entries such as UPC
actions, various bandwidth-related items, per VC thresholds, and so on.
Parameters necessary to configure the associated Class of Service buffers (Qbins) that provide QoS
support.
A service type identifier
QoS parameters (CLR, CTD, CDV)
Bandwidth parameters (such as PCR, MCR)
Other ATM Forum Traffic Management 4.0 parameters
Class of Service Templates and Qbins
Cisco BPX 8600 Series Installation and Configuration
23-25