Chapter 11 Installing The Ac Shelf; Installing An Ac Power Supply Tray - Cisco BPX 8620 Installation And Configuration Manual

Installing the AC Shelf
This chapter explains how to install the AC shelf.
Contents of this chapter include:
•
•
•
•
•
Before proceeding to this chapter, complete the procedures in either:
•
•

Installing an AC Power Supply Tray

The AC Power Supply Assembly is shipped separately and must be mounted directly below the BPX
switch shelf. It consists of a Power Supply Tray and one or two AC power supplies. The power supplies
are shipped separately from the AC Power Supply Tray.
Install power supplies after the BPX switch shelf is mounted in place.
All AC-powered systems are required to use a set of rear support brackets to provide additional support
for the rear of the Power Supply Tray.
To install the AC Power Supply Tray, use the following procedure:
Use two screws to attach each of two temporary support brackets and a temporary spacer bar to the rack
Step 1
(see Figure 11-1 and Figure 11-2).
Locate the small access hole in the top center of the front Air Intake Grille on the Power Supply Tray
Step 2
(see Figure 11-3).
Insert a slotted blade screwdriver (0.20/0.25 inch blade width) into the access hole until it stops
Step 3
(approximately 1 inch).
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Installing an AC Power Supply Tray
Installing an AC Power Supply
AC Power Input Connections
Card Slot Fuses
Fan Power Fuses
Chapter 8, "Installation with Cisco Cabinets including 7000 Series Routers"
or
Chapter 9, "Installation in Customer Cabinet"
C H A P T E R
Cisco BPX 8600 Series Installation and Configuration
11
11-1