Figure 13-3 Removing An Air Intake Grille - Cisco BPX 8620 Installation And Configuration Manual

Hide thumbs Also See for BPX 8620:

Table of Contents

Installing the BPX Switch Cards

Figure 13-3 Removing an Air Intake Grille

Insert a small slotted blade screwdriver (0.20/0.25 inch blade width) into the access hole until it stops

(approximately 1 inch).

Carefully rotate the screwdriver approximately a quarter turn in either direction. The top of the Air

Intake Grille should spring out.

Remove Air Intake Grille.

To remove a card, rotate the extractor handles at the top and bottom of the card to release the card and

slide it out.

To insert a new card, position the rear card guides over the appropriate slots at the top and bottom of the

Gently slide the card in all the way to the rear of the slot and seat the board by fully seating both extractor

handles. The handles should snap back to a vertical position when seated.

Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005

The card should slide in with slight friction on the adjacent board's EMI gaskets. Investigate

any binding. Do not use excessive force.

Cisco BPX 8600 Series Installation and Configuration

Installing the Cards

Bpx 8650 Bpx 8680 Bpx 8680-ip