Figure 20-3 Cisco Wan Manager Lan Connection Via Gateway Router To A Bpx Switch - Cisco BPX 8620 Installation And Configuration Manual

Configuring the LAN Port
Telnet
This Command: cnflan
Enter IP Address:
Connect the Cisco WAN Manager workstation and the BPX switch to a LAN network. The LAN port on
Step 3
the BPX switch provides a DB-15 connector that can be connected to a Y-cable which in turn is
connected to an AUI.
To test that a LAN connection to the BPX switch LAN port is okay, for example, for a host name of
Step 4
"sanfran" entered in the config.sv file, you would enter the following at the Cisco WAN Manager
workstation:
ping sanfran

Figure 20-3 Cisco WAN Manager LAN Connection via Gateway Router to a BPX Switch

193.287.107.1
Note: IP addresses are representative, only.
Step 5 An IP Relay address must be configured for each node. The following example shows an example of
using the cnfnwip command to configure the IP Relay address for a node:
beta
Active Network IP Address:
Active Network IP Subnet Mask:
This Command: cnfnwip
Enter active network IP address:
Also, at the workstation, the /etc/hosts table and routing must be set up for each node in the network.
This enables network management using SNMP and statistics collection using TFTP via inband ILMI.
Cisco BPX 8600 Series Installation and Configuration
20-8
READY
Backbone
192.187.207.11
192.187.207.200
AUI
Cisco WAN Manager
TN YourID
192.187.207.1
Default
gateway
192.187.210.30
192.187.210.30
BCC-LM
Sanfran
BPX 15 9.3 July 3 2000 02:11 PST
192.187.57.10
255.255.255.192
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Chapter 20 Configuring Network Management