Table of Contents
Advertisement
Installation Overview
This chapter describes an overview of the procedures used for configuration.
Contents of this chapter include:
•
•
•
The installation tasks introduced here are explained in detail in subsequent chapters.
For a description of the commands used to initially set up a BPX switch, refer to the Cisco WAN
Switching Command Reference and Cisco WAN Switching SuperUser Command Reference.
For additional information on network management and the graphical user interface recommended for
configuring and provisioning, refer to the Cisco WAN Manager User's Guide.
Summary of an Installation Procedure
This section summarizes the steps of an intstallation.
Step 1
Safety
Site Preparation
Step 2
Unpacking
Step 3
Installing shelf in cabinet or rack
Step 4
Step 5
Installing a Cisco 7200 or 7500 router on a BPX 8650
Optional Cable Management Tray
Step 6
Verifying 9.6 or 19.2 Gbps Backplane
Step 7
Upgrading to BCC-4 Cards
Step 8
Step 9
Installing APS Redundant Frame Assembly and Back Cards
Making T3 or E3 Connections
Step 10
Making a BXM OC3 or OC12 Connection
Step 11
Making a BXM T3/E3 Connection
Step 12
Setting up the BME OC-12 Port Loop
Step 13
Alarm Output Connections
Step 14
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Summary of an Installation Procedure
Installation Sequence Flow
Lines, Trunks, and Connection Configuration
C H A P T E R
Cisco BPX 8600 Series Installation and Configuration
6
6-1
Advertisement
Table of Contents
Troubleshooting
