Qbin Dependencies - Cisco BPX 8620 Installation And Configuration Manual

Chapter 23 Configuring BXM Virtual Switch Interface
Table 23-13 Connection Parameter Descriptions and Ranges (continued)
Object Name
Policing Action (GCRA #1)
Policing Action (GCRA #2)
VC Max
CLP Lo
CLP Hi
EFCI
VC Discard Threshold Selection
VS/VD
Reduced Format ADTF
Reduced Format Rate Decrease Factor
(RRDF)
Reduced Format Rate Increase Factor (RRIF) 1 to 15
Reduced Format Time Between Fwd RM
cells (RTrm)
Cut-Off Number of RM Cells (CRM)

Qbin Dependencies

Qbin templates deal only with Qbins that are available to VSI partitions, namely 10 through 15. Qbins
10 through 15 are used by VSI on interfaces configured as trunks or ports. The rest of the Qbins are
reserved and configured by Automatic Routing Management.
When you execute a dspsct command, it will give you the default service type, and the Qbin number.
The available Qbin parameters are listed in Table 23-14.
Notice that the Qbins available for VSI are restricted to Qbins 10 to 15 for that interface. All 32 possible
virtual interfaces are provided with 16 Qbins.
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Class of Service Templates and Qbins
Range/Values
0–Discard
1–Set CLP bit
2–Set CLP of
untagged cells,
disc. tagged cells
0–Discard
1–Set CLP bit
2–Set CLP of
untagged cells,
disc. tagged cells
0 to 100
0 to 100
0 to 100
0–CLP Hysteresis
1–EPD
0: None
1: VS/VD
2: VS/VD with external
Segment
0 to 7
1 to 15
0 to 7
1 to 4095
Cisco BPX 8600 Series Installation and Configuration
Template Units
enumeration
enumeration
cells
%Vc Max
%Vc Max
%Vc Max
enumeration
enumeration
enumeration
enumeration
enumeration
enumeration
cells
23-35