Chapter 12
Installing the T3/E3 Cable Management Tray
Routing Cables from Cards through Cable Management Tray
To route cables as shown in Figure 12-8, use the following procedure:
Verify that the cable management tray is in the lowered home position.
Step 1
Step 2
Route cables from the cards through the cable clamps on the cable management tray.
Step 3
Secure the cable management tray to the cable tray brackets by inserting and tightening the securing
screw, one to each bracket.
Figure 12-8 Cables Routed through Cable Management Tray in Lowered Position
To customer-supplied
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Securing screw
(one each side)
interface panel
Routing Cables from Cards through Cable Management Tray
Cisco BPX 8600 Series Installation and Configuration
Cable clamp
12-7