Chapter 11
Installing the AC Shelf
Figure 11-8 AC Power Supply Installation
Plunger
Align the power supply in the PS-A slots at the bottom of the Power Supply Tray and gently slide it in
Step 7
part way (see Figure 11-8).
Continue to slide the power supply in until it mates with the rear connector.
Step 8
When the power supply is completely seated in its connector, the pin plunger on the left side of the
Step 9
supply will engage with a hole in the tray. If not, push firmly on the front edge until the power supply
assembly seats in the connector.
Screw the right-hand thumbscrew in finger tight.
Step 10
When a second power supply is provided, install it in the PS-B slot in the same manner after removing
Step 11
the Blank Panel from Slot B.
Rotate the power supply retainer up and tighten the center captive screw.
Step 12
Install the Air Intake Grille. Press on the top center until the latch snaps into place.
Step 13
AC Power Input Connections
The following are the three configurations of the AC-powered BPX switch cabinet:
•
•
•
An 8−foot (3-meter) power cord is supplied with each AC Power Supply Assembly.
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Power supply
plunger hole
Power
supply
Power supply
thumb screw
Single power supply, single AC power feed
Dual power supplies, single AC power feed
Dual power supplies, dual AC power feed
Power supply
thumb screw
Retainer
captive
screw
Cisco BPX 8600 Series Installation and Configuration
AC Power Input Connections
Slot B empty if
non-redundant
Power supply
retainer
11-9