Table of Contents
Advertisement
Chapter 5
BXM Card Sets: T3/E3, 155, and 622
BXM Front Card Indicators
The BXM front panel has a three-section, multicolored "card" LED to indicate the card status. The card
status LED is color-coded as described in Table 5-3. A three-section multi-colored "port" LED indicates
the status of the ports.
Table 5-3
Status
port
card
Types of failures are indicated by various combinations of the card status indicators as described in
Table 5-4.
Table 5-4
act
on
off
off
on
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
BXM Front Panel Status Indicators
LED color
Status Description
off
Trunk/line is inactive and not carrying data.
green
Trunk/line is actively carrying data.
yellow-orange
Trunk/line is in remote alarm.
red
Trunk/line is in local alarm.
green (act)
Card is online and one or more trunks/lines on the card have been
upped. If off, card is operational but is not carrying traffic.
yellow-orange
Card is offline and in standby mode (for redundant card pairs).
(stby)
May not have any upped trunks/lines. If blinking, indicates card
firmware or configuration data is being updated.
red (fail)
Card failure; card has failed self-test and/or is in a reset mode.
BXM Front Panel Card Failure Indicators
stby
fail
off
on
on
on
blinking
on
on
on
Failure Description
Nonfatal error detected; card is still active.
Nonfatal error detected; card is in standby mode.
Fatal error detected; card is in a reboot mode.
Card failed boot load and operation is halted.
Cisco BPX 8600 Series Installation and Configuration
BXM Front Card Indicators
5-9
Advertisement
Table of Contents
Troubleshooting
