Auxiliary Port Parameters For Okidata 184 Local Printer; Dip Switch Settings For Okidata 184; Table 15-2 Auxiliary Port Parameters For Okidata 184 Printer; Table 15-3 Switch A Settings-Okidata 184 Printer - Cisco BPX 8620 Installation And Configuration Manual

Chapter 15 Connecting Temporary Terminal and Attaching Peripherals

Auxiliary Port Parameters for Okidata 184 Local Printer

The optional local maintenance printer for the BPX switch is the Okidata Model 184 dot matrix printer.
You may connect the printer to any node.
The printer configuration requirements are described in Table 15-2 and Table 15-3.

Table 15-2 Auxiliary Port Parameters for Okidata 184 Printer

Parameter
BPX switch Port Used:
Code:
Interface:
Data Rate:
Supported Printer:
Cable Required:

DIP Switch Settings for Okidata 184

The Dual Inline Package (DIP) switch A is an 8-section DIP switch located on the printer main circuit
board.
To access the configuration switches, slide back the switch cover at the top, rear of the printer case. The
settings for Switch A are listed in Table 15-3.
Table 15-3 Switch A Settings—Okidata 184 Printer
Switch A
1
2
3
4
5
6
7
8
The High Speed Serial Interface DIP switch consists of two DIP switches, SW1 and SW2, which is
located on a serial-board attached to the printer main board.
The settings for Switch 1 and Switch 2 are described in Table 15-4 and Table 15-5.
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Setting
Serial auxiliary port, located on the LM-BCC card, is used for the
maintenance printer
Standard 8-bit ASCII; 8 data bits, 1 stop-bit, odd parity
RS-232 DCE
9600 baud
Okidata 184
Straight-through RS-232 cable
Setting Description
Off ASCII with nonslashed zero
Off ASCII with nonslashed zero
Off ASCII with nonslashed zero
Off 11-inch paper length
On 11-inch paper length
Off No Auto Line Feed.
On 8-bit data.
Off Enables front panel.
Connecting a Network Printer to the BPX Switch
Cisco BPX 8600 Series Installation and Configuration
15-7