Motorola V.34R Bpx Switch Dial-In Configuration - Cisco BPX 8620 Installation And Configuration Manual

Chapter 15 Connecting Temporary Terminal and Attaching Peripherals

Motorola V.34R BPX Switch Dial-In Configuration

This section describes how to configure auto-answer mode for both the V.34R modem and the BPX
switch.
Enabling BPX Switch Auto-Answer (Dial-In to BPX switch)
To allow Cisco Customer Service to dial into your BPX switch to provide support and troubleshooting,
use the following procedure:
Use the cnfterm command to configure the BPX control port as follows:
Step 1
Next Command: cnfterm {a|c}[baud rate][data bits][stop bits][output flow
control{x|n}][input flow control{x|n}][CTS flow{x|n}][DTR{y|n}]
For parameter definitions that are used for the cnfterm command, refer to the Cisco WAN Switching
Command Reference, Release 9.3.30.
Set the BPX control port speed to 9600 bps.
Step 2
Use the cnftermfunc command to configure the Control port as follows:
Step 3
Next Command: cnftermfunc {a|c}[index]
For parameter definitions that are used for the cnftermfunc command, refer to the Cisco WAN Switching
Command Reference, Release 9.3.30.
Enter c to select the control port.
Step 4
Enter 1 as the index parameter for the terminal type to VT100/Cisco StrataView.
Step 5
To program the modem, temporarily attach a terminal to the modem using a straight through RS-232
Step 6
cable (DTE to DCE). The modem EIA port will automatically match the 9600 bps setting of the terminal.
To set up the modem for proper operation for the V.34R to auto-answer mode, for example, dial-in to
Step 7
BPX, enter the following commands:
Note
Command
AT & F
ATL1
ATSØ=1
AT\N3
AT%C
AT\QØ
AT&S1
ATEØ
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Consult the manual supplied with your modem for specifics concerning the modem
configuration. Contact Cisco Customer Service for the latest modem configuration
information.
Purpose
Reset to factory default.
Set the volume of the modem and speaker to low.
Enable the auto-answer mode on the modem to answer on the first ring.
Enable the automatic Microcom Networking Protocol (MNP) error
correction.
Disable data compression.
Disable XON/XOFF flow control.
Set the Data Set Ready (DSR) to normal.
Disable the local character echo. Modem cannot echo what you type.
Connecting Dial-In and Dial-Out Modems
Cisco BPX 8600 Series Installation and Configuration
15-13