Table of Contents
Advertisement
Installing the T3/E3 Cable Management Tray
This chapter provides instructions for the installation of the optional cable management tray that you can
use to route cables in an open-rack, nonredundant configuration.
Contents of this chapter include:
•
•
•
•
•
•
You must obtain the optional cable management tray kit and one each BXM T3/E3 cable bracket kit for
each BXM T3/E3 card.
Installation of Cable Management Tray
This section describes the steps to install the cable management tray.
Installing Tray Brackets
To install tray brackets, use the following procedure:'
Obtain brackets and associated hardware from the kit.
Step 1
Step 2
Install left and right brackets by using two nuts to secure each bracket (see Figure 12-1).
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Installation of Cable Management Tray
Raising Tray for Access to PEMs
Installing BXM T3/E3 Cable Bracket
Connecting Cables to BXM T3/E3 Cards
Routing Cables from Cards through Cable Management Tray
Tray Raised with Cables in Place
C H A P T E R
Cisco BPX 8600 Series Installation and Configuration
12
12-1
Advertisement
Table of Contents
Troubleshooting
