Figure 9-1 Bpx Switch Aligned With Temporary Support Brackets And Spacer Bar - Cisco BPX 8620 Installation And Configuration Manual

Installing a BPX Switch, Rear Rail Setback at 30-inch
Figure 9-1
BPX shelf
Slide the BPX switch shelf into the cabinet over the temporary support bar and brackets and into place
Step 2
over the flanges of the brackets previously attached to the rear rails of the cabinet.
Secure the BPX switch shelf to the front rail using 8 each #10-32 screws.
Step 3
Note
Locate the rear support brackets (P/N 215960-00B and 215960-01B) in the miscellaneous parts kit.
Step 4
Step 5 Position the adjustable plates with the tabs in the three punchouts facing up as shown in Figure 9-3.
Align the top and bottom holes in the adjustable plates with corresponding holes in the side panel of the
Step 6
BPX switch shelf. (The bottom of the plates should be approximately aligned with the bottom of a
DC- powered BPX switch shelf. They should be extended below the bottom of an AC-powered BPX
switch shelf so that the AC Power Supplies can be secured to the shelf.)
Step 7 Secure one each adjustable plate to each side of the BPX switch shelf, using (2) each #10-32 machine
screws and flat washers.
Step 8 Attach a rear support bracket to each one of the adjustable plates with 2 each #10-32 screws and washers.
Do not tighten yet.
Secure the support brackets to the rear located vertical rails using 2 each #10-32 screws. You might have
Step 9
to lift the BPX switch shelf slightly to align the holes in the bracket to the holes in the rack.
Tighten the screws attaching the support bracket to the adjustable plate.
Step 10
Slide a cable strap over each of the three tabs on the support brackets.
Step 11
Step 12 Remove the temporary support bracket and spacer bracket from the front of the cabinet.
Cisco BPX 8600 Series Installation and Configuration
9-2
BPX Switch Aligned with Temporary Support Brackets and Spacer Bar
European installations may use a size M6 metric screw.
Chapter 9
Temporary
support
bracket
Temporary
spacer bar
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Installation in Customer Cabinet