This guide provides detailed instructions for installing the Ellipse Series of Contribution Encoders.
Topics:
General Directives
Installation Instructions
Powering Up and Initialization
General Directives
Safety Precautions
To avoid injury and prevent equipment damage, observe the following safety precautions:
Do not move or ship equipment unless it is correctly packed in its original wrapping and
shipping containers.
Only Harmonic trained personnel can undertake equipment service and maintenance.
To prevent damage by lightning, ground the unit according to local regulations.
Do not permit unqualified personnel to operate the unit.
Power Supply to the Unit
To ensure correctly and safely operation of the unit, the following are required:
Adding to the system a UPS (Uninterrupted Power Supply) and an AVR (Automated Voltage
Regulator) is highly recommended.
Installing the main power supply by a qualified electrician, according to power authority
regulations. Make sure all powering are wired with an earth leakage, according to local
regulations.
It is recommended to install the encoder within 1.5m (approx. 5 feet) from an easily accessible
grounded AC outlet.
When the encoder is rack-mounted, ensure that the rack is correctly grounded.
DANGER: Ensure that the rack is correctly grounded by a qualified electrician. Incorrectly grounded
equipment may result in electrical shock.
Inventory Check
Before installation, ensure that all the equipment and the attached parts are available and
undamaged, according to the following list:
Ellipse 3000 Contribution Encoder
Ellipse 3000 Installation Guide
© 2014 Harmonic Inc. All rights reserved.
Ellipse™ 3000 Installation Guide
Item
6
Quantity
1 Unit
1 Shared CD
Ellipse 3000 Release 3.3, Rev A
Chapter 1