Master Cylinder And Reservoir - GMC G Service Manual

7C-6 CLUTCH
• Install the screw in the direction from which it
was removed.
9. New spring washer (121) and the nut (120).
10. Neutral start switch (125) in the position from which it
was removed.
11. New wave washer (130).
12. Washer (131) and a new cotter pin (132).
13. Negative battery cable.
• Adjust the clutch linkage. Refer to "Free Travel
Adjustment" in this section.
• Lubricate the clutch pedal. Refer to MAINTENANCE
AND LUBRICATION (SEC. OB).
MASTER CYLINDER AND
RESERVOIR
H Remove or Disconnect (Figure 3)
1. Negative battery cable.
2. Lower steering column covers.
3. Lower left side air conditioning duct (if used).
4. Retainer (105) and washer (106).
5. Push rod (107) and wave washer (108).
6. Reservoir hose (145).
10. Screws (146) and the reservoir (140).
10. Negative battery cable.
Figure 3 — Master Cylinder and Reservoir
7. Secondary cylinder hydraulic line (142)
ter cylinder (144).
8. Nuts (143) and the master cylinder (144).
9. Gasket (141).
• Scrape all gasket material from the master cyl­
inder and the cowl.
install or Connect (Figure 3)
1. Reservoir (140) and screws (146).
2. New gasket (141).
3. Master cylinder (144) and nuts (143).
4. Secondary cylinder hydraulic line (142) to the master
cylinder (144).
5. Reservoir hose (145).
6. New wave washer (108) and the push rod (107).
7. Washer (106) and retainer (105).
8. Lower left side air conditioning duct, if used.
9. Lower steering column covers.
• Fill the reservoir. Refer to "Specifications" in this
section.
• Bleed the clutch system. Refer to "Hydraulic Clutch
Bleeding" in this section.
the mas­
f ro m