Door Lock Cylinder Replacement; Door Lock Control Assembly Replacement - GMC G Service Manual

10A1-46 POORS
260
253. Bolt
254. Small Gasket
255. Door Handle
256. Large Gasket
Figure 68 — Outside Handle and Lock Cylinder
E
Components
Install or Connect (Figure 68)
1. Large gasket onto the handle.
2. Door to outside handle screw (253) to the push button
side of the handle.
• Do not tighten.
3. Small gasket between the door and the handle.
4. Door to outside handle screw (253) to the other side
of the handle.
• Tighten both screws.
5. Door trim panel. Refer to "Door Trim Panel
Replacement."
DOOR LOCK CYLINDER
E
REPLACEMENT
Remove or Disconnect (Figure 68)
• Raise the window completely.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Lock cylinder retaining clip from the cylinder.
• Slide the clip off the cylinder with a screwdriver.
3. Lock cylinder and gasket from the door.
257. Retainer
258. Key
259. Lock Cylinder
260. Gasket
F-00496
H Install or Connect (Figure 68)
1. Lock cylinder with gasket to the door.
• The cylinder rod must engage the lock assem­
bly lever.
2. Lock cylinder retaining clip onto the cylinder.
3. Door trim panel. Refer to "Door Trim Panel
Replacement."
DOOR LOCK CONTROL ASSEMBLY
REPLACEMENT
H Remove or Disconnect (Figure 69)
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Door panel to control assembly screws (262).
3. Control assembly from the lock assembly rod.
• Pivot the clip away from the rod at the control
assembly.
• Twist the control assembly off the rod.
4. Control from the vehicle.
Figure 69 — Door Lock Control