Utility Vehicle Passenger Front Bucket Seat Replacement; Front Pivot Bracket Disassembly - GMC G Service Manual

10A2-4 SEATS
B
Install or Connect (Figures 2 and 3)
1. Adjuster (2) to the seat (10).
2. Adjuster to seat bolts (8).
3. Seat (10) with adjuster (2) to the vehicle.
4. Seat adjuster to floor panel bolts (7).
5. Bolt cover (5) (if equipped).
UTILITY VEHICLE PASSENGER
FRONT BUCKET SEAT
REPLACEMENT
B
Remove or Disconnect (Figure
• Place the seat in its forward position.
1. Restraint cable (19) to the floor panel bolt (22).
• Allow the seat to tip forward.
2. Spring retaining bracket bolts (12) and the bracket
(13).
3. Lower seat bracket (23) to the floor panel bolts (20).
4. Seat from the vehicle.
5. Upper seat bracket bolts (15).
6. Seat brackets (14) from the seat.
7. Latch assembly to seat bolts.
8. Latch assembly from the seat.
Wire Assembly
Adjuster
Spring
Bolt
Bolt
Bracket
Seat
B
1. Latch assembly to the seat.
2. Latch assembly to seat bolts.
3. Seat brackets (14) to the seat.
4. Upper seat bracket bolts (15).
5. Seat to the vehicle.
6. Lower seat bracket (23) to the floor panel bolts (20).
7. Spring retaining bracket (13) onto the springs (21),
8. Restraint cable (19) to the floor panel bolts (22).
4)
This procedure applies only to Utility Vehicle passenger
front bucket seats.
B
1. Seat. Refer to "Utility Vehicle Passenger Front Bucket
2. Nut (18).
3. Washer (17).
4. Pivot stud (25).
5. Sleeve (24).
6. Springs (21).
7. Upper bracket (14) from the lower bracket (23).
Figure 3 — Bucket Seat Components
Install or Connect (Figure
and the spring retaining bracket bolts (12).
FRONT PIVOT BRACKET
DISASSEMBLY
Remove or Disconnect (Figure 4)
Seat Replacement."
4)