Door Outside Handle Replacement; Door Lock Cylinder Replacement - GMC G Service Manual

M Install or Connect (Figure 19)
1. Motor into the door.
2. Motor to the lock rod.
• Slide the rubber mount at the top of the motor
onto the door lock rod.
3. Door to motor screws (78).
4. Electrical connector to the motor.
5. Door trim panel. Refer to "Door Trim Panel
Replacement."
6. Battery ground cable.
DOOR OUTSIDE HANDLE
REPLACEMENT
H Remove or Disconnect (Figure 20)
• Raise the window completely.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Outside door handle to lock rod clip.
• Using a flat bladed screwdriver, push on the top
of the clip where it is connected to the rod. Pivot
the clip away from the rod.
3. Outside door handle to lock rod from the lock.
4. Door to outside handle screws (54).
5. Handle with the control rod from the door.
6. Gaskets from the door.
M Install or Connect (Figure 20)
1. Large gasket over the lock rod and onto the handle.
2. Handle with the lock rod onto the door.
3. Door to outside handle screw (54) to the push button
side of the handle.
• Do not tighten.
4. Small gasket between the door and the handle.
5. Door to outside handle screw (54) to the other side of
the handle.
• Tighten both screws.
6. Outside door handle to lock rod to the lock assembly.
7. Clip onto the lock rod.
• Pivot the clip up and onto the lock rod.
8. Door trim panel. Refer to "Door Trim Panel
Replacement."
DOOR LOCK CYLINDER
REPLACEMENT
H Remove or Disconnect (Figure 20)
• Raise the window completely.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Lock cylinder retaining clip (62) from the cylinder.
• Slide the clip off the cylinder with a screwdriver.
3. Lock cylinder and gasket from the door.
B Install or Connect (Figure 20)
1. Lock cylinder with gasket to the door.
• The cylinder rod must engage the lock assem­
bly lever.
2. Lock cylinder (62) retaining clip onto the cylinder.
3. Door trim panel. Refer to "Door Trim Panel
Replacement."
DOORS 10A1-13