Stationary Glass/Window Run Channel Assembly Replacement - GMC G Service Manual

STATIONARY GLASS/WINDOW RUN
CHANNEL ASSEMBLY
REPLACEMENT
The stationary glass and the rear window run channel
are one assembly. This assembly fits into the rear of the
door frame.
H Remove or Disconnect (Figure 29)
• Place the window in the lowered position.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Run channel molding (96).
• Pull the molding out of the run channel only.
3. Door panel to run channel bolt (99).
4. Door frame to run channel screw (97).
5. Stationary glass/window run channel assembly from
the door.
• Pull the top of the channel backwards away
from the door frame.
• Lift and rotate the assembly out of the door.
Figure 28 — Door Trim Panel Components
E
POORS 10A1-19
Install or Connect (Figure 29)
Stationary glass/window run channel assembly to the
1
.
door.
• Rotate the vent assembly into the door.
• Fit the assembly into the door frame.
2. Run channel molding.
• Push the molding into the run channel. The slot
at the top of the molding must be on top of the
run channel.
3. Door frame to run channel screw (97).
• The screw must pass through the run channel
molding slot.
4. Door panel to run channel bolt (99).
5. Door trim panel. Refer to "Door Trim Panel
Replacement."