Door Adjustment - GMC G Service Manual

DOOR ADJUSTMENT

H Remove or Disconnect
Tool Required:
J 29843-9 Wrench
• Door striker bolt using J 29843-9 (figure 4)
0 Adjust (Figure 27)
• The door up or down, forward or rearward, and
in or out, at the door hinges.
1. Adjust the door to obtain a gap of 6 mm ± 2 mm
(0. 24-inch ± 0.09-inch) between the rocker panel
and the door.
2. The gap between the door and the roof panel should
be 5 mm ± 2 mm (0.19-inch ± 0.09-inch).
3. Adjust the door to obtain a gap of 5 mm ± 2 mm
(0 .19-inch ± 0.09 inch) between the doors rear edge
and the rear door pillar.
Figure 26 — Door Hinge Components
4. The gap between the door and the center pillar
5. The door surface should be flush with the other
H
NOTICE: Refer to "Notice" on page 10A1-1 of this
section.
•
DOORS 10A1-17
should be 5 mm ± 2 mm (0.19-inch ± 0.09-inch).
panels within ± 1.5 mm ( ± 0.06-inch) except for the
door to roof panel surface which should be flush
within + 1.5 mm (+ 0.06-inch).
Install or Connect
D o o r strik e r bolt.
\ ^ \ Adjust
• Bolt to properly engage the door lock.
I^ \ l Tighten
• Striker bolt to 63 N«m (46 ft. lbs.).
F-00465