Lower Roller Assembly Replacement; Upper Front Roller Replacement; Door Adjustment - GMC G Service Manual

10A1-62 POORS
395
393
LOWER ROLLER ASSEMBLY
REPLACEMENT
H Remove or Disconnect (Figure 94)
• Mark the position of the assembly to the bracket on
the roller assembly.
1. Roller assembly to door bracket bolts (401).
2. Catch clip (400) and rod from the catch.
3. Pivot the roller assembly out of the lower door track.
B
Install or Connect (Figure 94)
1. Pivot the roller assembly into the lower door track.
2. Roller assembly to door bracket bolts (401).
• Align the roller assembly to the previously made
mark.
3. Catch clip (400) and rod to the catch.
Figure 94 — Lower Front Roller Assembly
387
Figure 93 — Upper Rear Hinge Components
396. Bolt
397. Striker
398. Roller Assembly
399. Catch
400. Clip
401. Bolt
398
F-00524
389 390
UPPER FRONT ROLLER
REPLACEMENT
l+"»l Remove or Disconnect (Figure 92)
1. Roller molding (if equipped).
2. Plastic cap (if equipped).
3. Bracket to door bolts (386) (figure 97).
4. Roller from the track.
F + l Install or Connect (Figure 92)
1. Roller into the track.
2. Bracket to door bolts (386) (figure 97).
3. Plastic cap (if equipped).
4. Roller molding (if equipped).

DOOR ADJUSTMENT

B
UP AND DOWN ADJUSTMENT
Remove or Disconnect (Figure 95)
Tool Required:
J 29843-9 Door Striker Wrench
1. Upper rear hinge cover.
2. Front lock striker (404).
3. Rear lock striker (405) using J 29843-9 (figure 4).
4. Rear door wedge assembly (407).
Adjust (Figure 96)
The rear edge of the door to obtain a gap of 4.5 mm
± 0.5 mm (0.18-inch) ± 0.02-inch) between the top
of the door and the roof side rail. This adjustment
should provide a gap of 6 mm ± 0.5 mm (0.25-inch
± 0.02-inch) between the bottom of the door and the
rocker panel. To accomplish this adjustment, loosen
the upper rear hinge to door bolts (figure 92), and
align the rear edge of the door up or down. Next,
tighten the upper rear hinge to door bolts (figure 93).
380. Cover Retainer
387. Spring
388. Bolt
389. Washer
390. Nut
391. Screw
392. Bolt
393. Retainer
394. Hinge Assembly
395. Striker
A. Lubrication Points
F-00523