Utility Vehicle Rear Seat Replacement; Utility Vehicle Rear Seat Cover Rod Replacement - GMC G Service Manual

10A2-16 SEATS
H Install or Connect (Figure
NOTICE: For steps 2 and 4 see " Notice" on page
10A2-1 of this section.
1. Retractor (112) to the floor panel.
2. Retractor to floor panel bolts (115).
I $ ] Tighten
• Bolts to 50 N«m (37 ft. lbs.).
CENTER BUCKLE AND LATCH PLATE REPLACEMENT
M Remove or Disconnect (Figure 19)
1. Seat. Refer to "Crew Cab Rear Seat Replacement."
• Note the position of the belts.
2. Belt to floor panel bolts (114).
3. Left belt (113) and right belt (113) from the vehicle.
R Install or Connect (Figure
1. Left belt (113) and right belt (113) to the vehicle.
NOTICE: See Notice
" "
section.
Figure 19 — Crew Cab Rear Seat Belt Components
19)
19)
on page 10A2-1 of this
2. Belt to floor panel bolts (114).
I f f l Tighten
• Bolts to 50 N-rn (37 ft. lbs.).
3. Seat. Refer to "Crew Cab Rear Seat Replacement."
UTILITY VEHICLE REAR SEAT
REPLACEMENT
□ Remove or Disconnect (Figure 20)
• Fold the seat forward.
1. Hinge to floor bolt (116) and spring washer (117).
2. Seat from the vehicle.
M Install or Connect (Figure 20)
1. Seat to the vehicle.
2. Spring washer (117) and bolt (116).
UTILITY VEHICLE REAR SEAT
COVER ROD REPLACEMENT
M Remove or Disconnect (Figure 21)
1. Actuator rod clip (123).
2. Actuator rod (124).
Retractor
Buckle
Bolt
Bolt
B-07262