Vent Window Adjustment; Door Window Replacement; Window Stop Assembly Adjustment; Inner Window Weatherstrip Replacement - GMC G Service Manual

10A1-42 POORS

VENT WINDOW ADJUSTMENT

\ M Adjust (Figure 63)
• Remove the door trim panel. Refer to "Door Trim
Panel Replacement."
• Bend the tabs on the adjustment nut away from the
nut.
• Adjust the vent by placing a wrench on the adjusting
nut, and then turning the vent window to the proper
tension.
• Bend the tabs over the adjustment nut.
• Install the door trim panel. Refer to "Door Trim Panel
Replacement."

DOOR WINDOW REPLACEMENT

M Remove or Disconnect (Figure 64)
CAUTION: Always wear heavy gloves when han­
dling glass to minimize the risk of injury.
• Lower the glass to the bottom of the door.
1. Door trim panel. Refer to "Door Trim Panei
Replacement."
2. Door vent/window run channel assembly. Refer to
"Door Vent/Window Run Channel Assembly
Replacement."
• Mask or cover any sharp edges that could scratch the
glass.
3. Door window glass (230).
• Slide the glass forward until the front roller is in
line with the notch in the sash channel. Disen­
gage the roller from the channel.
• Push the window forward, then tilt it up until the
rear roller is disengaged.
• Place the window in a level position, and raise it
straight up and out of the door.
Install or Connect (Figure 64)
1. Door window glass (230).
• Lower the window into the door frame.
• Push the window forward, then tilt it up, and
slide the rear roller into the sash channel.
• Slide the glass backward until the front roller is
in line with the notch in the sash channel.
Engage the roller to the sash channel.
• Slide the glass rearward into the glass run
channel.
• Remove any masking or covering.
2. Door vent/window run channel assembly. Refer to
"Door Vent/Window Run Channel Assembly
Replacement."
3. Door trim panel. Refer to "Door Trim Panel
Replacement."
WINDOW STOP ASSEMBLY
ADJUSTMENT
1. Remove the door trim panel. Refer to "Door Trim
Panel Replacement."
2. Lower the window until it is flush with the window sill.
3. Loosen the glass stop bolt, and adjust the stop until
the glass is completely flush with the window sill (fig­
64).
ure
4. Tighten the bolt.
5. Install the trim pad. Refer to "Door Trim Panel
Replacement."
INNER WINDOW WEATHERSTRIP
REPLACEMENT
0 Remove or Disconnect (Figure 64)
• Lower the window.
• Weatherstrip from the door.
• Pry the weatherstrip clips from the door panel.
h H install or Connect (Figure 64)
• Weatherstrip to the door.
• Push the weatherstrip clips onto the door panel.
OUTER WINDOW WEATHERSTRIP
REPLACEMENT
M Remove or Disconnect (Figure 64)
• Lower the window.
• Weatherstrip from the door.
• Pry the weatherstrip clips from the door panel.
M Install or Connect (Figure 64)
• Weatherstrip to the door.
• Push the weatherstrip clips onto the door panel.