Door Lock Replacement; Power Door Lock Motor Replacement; Door Outside Handle Replacement - GMC G Service Manual

110. Bolt
111. Wiring Harness
112. Nut
113. Regulator Assembly
Figure 33 — Power Regulator

DOOR LOCK REPLACEMENT

H Remove or Disconnect (Figure 34)
• Raise the window completely.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Inside door handle to lock rod clip (115).
• Using a flat bladed screwdriver, push on the top
of the clip where it is connected to the rod. Pivot
the clip away from the rod.
3. Inside door handle to lock rod from the lock.
4. Outside door handle to lock rod clip.
• Use the procedure given under step 2.
5. Outside door handle to lock rod from the lock.
6. Remove control to lock assembly clip and rod.
7. Door to lock assembly screws (116).
8. Lock assembly from the door.
• Tilt the lock assembly away from the outside
lock cylinder. Pull the lock assembly downward
to make clearance for the inside lock rod.
Install or Connect (Figure 34)
1. Lock assembly to the door.
• Tilt the lock assembly onto the outside lock
cylinder.
2. Door to lock assembly screws (116).
110
F-00475
3. Remote control to lock assembly rod and clip.
4. Outside door handle to lock rod onto the lock
assembly.
5. Clip onto the lock rod.
• Pivot the clip up and onto the lock rod.
6. Inside door handle to lock rod onto the lock assembly.
7. Clip onto the lock rod.
• Pivot the clip up and onto the lock rod.
8. Door trim panel. Refer to "Door Trim Panel
Replacement."
POWER DOOR LOCK MOTOR
REPLACEMENT
Refer to CAB ELECTRICAL (SEC. 8A) for electrical
E
diagnosis of the door lock motor.
Remove or Disconnect (Figure 34)
1
. Battery ground cable.
2. Door trim panel. Refer to "Door Trim Panel
Replacement."
3.
Electrical connector from the motor.
4.
Door to motor screws.
5. Motor from the lock rod.
• Slide the rubber mount at the top of the motor
off of the door lock rod.
B
6. Motor from the door.
Install or Connect (Figure 34)
1. Motor into the door.
2. Motor to the lock rod.
• Slide the rubber mount at the top of the motor
onto the door lock rod.
3. Door to motor screws.
4.
Electrical connector to the motor.
5. Door trim panel. Refer to "Door Trim Panel
Replacement."
6. Battery ground cable.
DOOR OUTSIDE HANDLE
REPLACEMENT
M Remove or Disconnect (Figure 35)
• Raise the window completely.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Outside door handle to lock rod clip.
• Using a flat bladed screwdriver, push on the top
of the clip where it is connected to the rod. Pivot
the clip away from the rod.
3.
Outside door handle to lock rod from the lock.
4. Door to outside handle screws (174).
POORS 10A1-23