Rear Lock Replacement; Lock Cylinder Replacement; Sliding Side Door Weatherstrip Replacement - GMC G Service Manual

REAR LOCK REPLACEMENT

H Remove or Disconnect (Figure 105)
1. Lock rods from the lock.
• Pivot the clip from the rod, and pull the rod from
the lock.
2. Lock to door screws (457).
3. Lock from the door through the access hole.
B install or Connect (Figure 105)
1. Lock to the door through the access hole.
2. Lock to door screws (457).
3. Lock rods to the lock.
• Pivot the clip onto the rod.

LOCK CYLINDER REPLACEMENT

H H Remove or Disconnect (Figure 106)
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Door lock cylinder rod (450).
3. Cylinder retainer (462).
• Pry the retainer from the lock.
4. Cylinder (464) and seal (463) from the door.
Figure 104 — Door Lock Attachment
M
1. Cylinder (464) and seal (463) to the door.
2. Cylinder retainer (462).
3. Door lock cylinder rod (450).
4. Door trim panel. Refer to "Door Trim Panel
WEATHERSTRIP REPLACEMENT
0
1. Weatherstrip from the door using 3M Release Agent
2. Plastic nails from the door.
• The door of all the old cement.
H
1. Weatherstrip adhesive to the door. Use 3M
2. New weatherstrip to the door.
DOORS 10A1-69
Install or Connect (Figure 106)
• Push the retainer onto the cylinder.
Replacement."
SLIDING SIDE DOOR
Remove or Disconnect (Figure 107)
(or equivalent).
Install or Connect (Figure 107)
Weatherstrip Adhesive (or equivalent).
• Press the plastic nails into the door.