On-Vehicle Service; Hydraulic Clutch Pedal - GMC G Service Manual

7C-4 CLUTCH

HYDRAULIC CLUTCH PEDAL

R Remove or Disconnect (Figure 1)
1. Negative battery cable.
2. Lower steering column covers.
3. Lower left side air conditioning duct (if used).
4. Neutral start switch.
5. Retainer (105) and the washer (106).
6. Pushrod (107) and the wave washer (108).
7. Nuts (100).
8. Braces (102 and 112).
9. Stud (101), pedal (109) and spring (103).
• Slide a long screw or rod into the bracket while
removing the stud.
10. Bushings (104) and the spacer (110).
11. Bumper (111) if it is worn or damaged.
R install or Connect (Figure 1)
1. New bumper (111) if needed.
2. New spacer (110) and new bushings (104).
• Coat with grease before installing.
3. Spring (103), pedal (109) and stud (101).
• Remove the long screw or rod while installing
the stud.
[ ] Important
• The stud must be installed in the direction
shown.
4. Braces (102 and 112).
5. Nuts (100).
6. New wave washer (108) and the push rod (107).
• The washer must stand off the pedal as shown.
7. Washer (106) and the retainer (105).
8. Neutral start switch.
9. Lower left side air conditioning duct, if used.
10. Lower steering column covers.

ON-VEHICLE SERVICE

11. Negative battery cable.
• Lubricate the clutch pedal. Refer to MAINTENANCE
AND LUBRICATION (SEC. 0B).
100. Nut
101. Stud
102. Outboard Brace
103. Spring
104. Bushing
105. Retainer
106. Washer
Figure 1 — Hydraulic Clutch Pedal Components
107. Pushrod
108. Wave Washer
109. Pedal
110. Spacer
111. Bumper
112. Inboard Brace
LOO187