Door Trim Panel Replacement; Window Replacement - GMC G Service Manual

10A1-66 POORS
DOOR HOLD OPEN CATCH ADJUSTMENT (Figure 94)
1. Mark the position of the lower roller assembly to the
bracket.
2. Loosen the lower roller assembly bolts (401).
3. Pivot the lower roller assembly to properly engage the
latch striker.
4. Tighten the lower roller assembly bolts (401).
REAR WEDGE ASSEMBLY ADJUSTMENT (Figure 99)
1. Loosen the rear wedge assembly screws (408).
2. Completely close the door.
3. From inside the vehicle, center the wedge assembly
(407) onto the door wedge.
4. Mark the position of the wedge assembly.
5. Open the door, and move the wedge assembly for­
ward 4.7 mm (3/16-inch).
6. Tighten the rear wedge assembly screws (408).
Figure 99 — Rear Wedge Adjustment
DOOR TRIM PANEL
REPLACEMENT
B
Remove or Disconnect (Figure 100)
1. Inside door handle screw (429).
B
crisscrossed with masking tape to reduce the risk of injury
and/or damage to the vehicle. If a crack extends to the edge
of the glass, mark the door with a piece of chalk at the point
where the crack meets the weatherstrip. Later, when exam­
ining the flange of the opening for a cause of the crack, start
at the point marked.
and the condition corrected, before the new glass is
installed. The cause of the crack may be an obstruction or
high spot somewhere around the flange of the opening;
cracking may not occur until pressure from the high spot or
obstruction becomes particularly high due to winds,
extremes of temperature, or rough terrain.
B
STATIONARY GLASS
Figure 100 — Door Trim Panel Components
2. Inside door handle (422).
3. Inside door handle cover (430).
4. Lock knob (428).
• Pull the knob from the door.
5. Door assist strap screws (425), and assist strap
(423).
6. Trim panel to door screws (427).
7. Trim panel from the door.
install or Connect (Figure 100)
1. Trim panel to the door.
2. Trim panel to door screws (427).
3. Door assist strap (423) and assist strap screws (425).
4. Lock knob (428).
5. Inside door handle cover (430).
6. Inside door handle (422).
7. Inside door handle screw (429).

WINDOW REPLACEMENT

If a glass is cracked but still intact, it should be
It is important that the cause of the crack be determined
Remove or Disconnect (Figure 101)
CAUTION: Always wear heavy gloves when han­
dling glass to minimize the risk of injury.
422. Inside Handle
423. Assist Strap
424. Door Trim Panel
425. Screw
426. Cover
426
427. Screw
428. Lock Knob
429. Screw
430. Cover
427
F-00541