Utility Vehicle Rear Seat Belt Replacement; Utility Vehicle And Suburban Seatback And Hinge Replacement - GMC G Service Manual

10A2-18 SEATS
UTILITY VEHICLE REAR SEAT
BELT REPLACEMENT
H Remove or Disconnect (Figure 21 and 23)
• Fold the seat fonward.
1. Side latch plate (128) to floor panel bolts (129).
2. Side latch plate (128) from the vehicle.
3. Rear seat cover rod (124) (figure 23).
4. Latch and support assembly from the seat. Refer to
"Utility Vehicle and Suburban Latch and Support
Assembly Replacement."
5. Seat belt (130) to latch bolts (131).
6. Seat beits from the latch.
Install or Connect (Figure 21 and 23)
NOTICE: For steps 2 and 6 see " Notice" on page
10A2-1 of this section.
1. Seat belts (130) to the latch.
2. Seat belts (130) to latch bolts (131).
H O Tighten
• Bolts to 50 N*m (37 ft. lbs.).
3. Latch and support assembly to the seat. Refer to
"Utility Vehicle and Suburban Latch and Support
Assembly Replacement."
4. Rear seat cover rod.
UTILITY VEHICLE AND SUBURBAN
M
H
Figure 23 — Utility Vehicle Rear Seat Belts
5. Side latch plate (128) to the vehicle.
6. Side latch plate (128) to floor panel bolts (129).
IS il Tighten
• Bolts to 50 N«m (37 ft. lbs.).
SEATBACK AND HINGE
REPLACEMENT
Remove or Disconnect (Figures 24 and 25)
1. Seatback to hinge bolts (139).
2. Seatback (154) from the vehicle.
3. Hinge (153) to seat bottom bolts (137).
4. Hinge (153) from the vehicle.
5. Armrest to hinge bolt (136).
6. Armrest support (138) from the hinge.
Install or Connect (Figures 24 and 25)
1. Armrest (133) to the hinge.
2. Armrest to hinge bolt (136).
3. Hinge (153) to the vehicle.
4. Hinge (153) to seat bottom bolts (137).
5. Seatback (154) to the vehicle.
6. Seatback to hinge bolts (139).