Power Door Lock Motor Replacement; Intermediate Front Door Weatherstrip Replacement - GMC G Service Manual

10A1-58 DOORS
POWER DOOR LOCK MOTOR
REPLACEMENT
Refer to CAB ELECTRICAL (SEC. 8A) for electrical
B
diagnosis of the door lock motor.
Remove or Disconnect (Figure 87)
1. Battery ground cable.
2. Door trim panel. Refer to "Door Trim Panel
Replacement."
3. Electrical connector from the motor.
4. Door to motor screws (370).
5. Motor from the lock rod.
• Slide the rubber mount at the top of the motor
off of the door lock rod.
6. Motor from the door.
B
Install or Connect (Figure 87)
1. Motor into the door.
2. Motor to the lock rod.
• Slide the rubber mount at the top of the motor
onto the door lock rod.
3. Door to motor screws (370).
4. Electrical connector to the motor.
5. Door trim panel. Refer to "Door Trim Panel
Replacement."
6. Battery ground cable.
Figure 86 — Intermediate Rear Door Control Assembly
Figure 87 — Power Door Lock Motor Attachments
INTERMEDIATE FRONT DOOR
WEATHERSTRIP REPLACEMENT
h"H Remove or Disconnect (Figure 88)
1. Weatherstrip from the door using 3M Release Agent
(or equivalent).
2. Plastic nails from the door.
353. Control Assembly
354. Clip
355. Lock Rod
356. Lock Knob
357. Ferrule
358. Screw
359. Protector
360. Spring
361. Striker
362. Washer
363. Bolt
364. Screw
365. Handle
F-00515