Laminated (Printed) Circuit Replacement; Ignition Switch Replacement; Lamp Switch Replacement; Special Tools - GMC G Service Manual

7. Cluster.
• Pull the top of the cluster away from the instru­
ment panel.
• Lift out bottom of the cluster.
8. Instrument cluster harness connector.
f»<-| Install or Connect (Figure 6)
1. Cluster harness connector into the cluster.
2. Cluster.
3. Two lower cluster retaining screws.
4. Instrument bezel (84).
5. Instrument cluster bezel retaining screws.
6. Clock set stem knob.
7. Speedometer drive cable.
8. Battery ground cable to the battery.
P MODELS
|<"»| Remove or Disconnect
1. Battery ground cable from the battery.
2. Speedometer drive cable.
• Press in the tang on the speedometer head.
• Pull out of the drive cable.
3. Instrument cluster harness connector.
4. Instrument cluster bezel screws.
5. Instrument cluster from the dash panel.
[»♦[ Install or Connect
1. Instrument cluster to the dash panel.
2. Instrument cluster bezel screws.
3. Instrument cluster harness connector.
4. Speedometer drive cable.
5. Battery ground cable from the battery.
LAMINATED (PRINTED) CIRCUIT
ALL MODELS
|<"»| Remove or Disconnect (Figures 4, 5, and 6)
1. Instrument cluster assembly. Refer to "Instrument
2. Instrument cluster lamp bulb assemblies.
3. Laminated circuit retaining screws.
4. G and P models.
5. Laminated circuit (32) from the cluster case (33).
I * * ! Install or Connect (Figures 4, 5, and 6)
1. Laminated circuit (32) to the cluster case (33).
2. Laminated circuit retaining screws.
3. G and P models.
4. Instrument cluster lamp bulb assemblies.
5. Instrument cluster assembly. Refer to "Instrument

IGNITION SWITCH REPLACEMENT

Refer to STEERING COLUMN (SEC. 3B4)

LAMP SWITCH REPLACEMENT

Refer to CHASSIS ELECTRICAL (SEC. 8B).

SPECIAL TOOLS

Figure 11 — Special Tools
INSTRUMENT PANEL 8C-17
REPLACEMENT
Cluster Replacement" in this section.
• Fuel gage terminal nuts.
• Temperature gage terminal nuts.
• Ammeter terminal nuts.
• Fuel gage terminal nuts.
• Ammeter terminal nuts.
Cluster Replacement" in this section.