Door Window Replacement; Inner Window Weatherstrip Replacement - GMC G Service Manual

10A1-20 POORS
Figure 29 — Stationary Glass/Window Run Channel
Components

DOOR WINDOW REPLACEMENT

M Remove or Disconnect (Figure 30)
CAUTION: Always wear heavy gloves when han­
dling glass to minimize the risk of injury.
• Lower the window to the bottom of the door.
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Stationary glass/window run channel assembly.
Refer to "Stationary Glass/Window Run Channel
Assembly Replacement."
• Mask or cover any sharp edges that could scratch the
glass.
3. Door window glass
(100).
• Slide the glass rearward until the rear roller is in
line with the notch in the sash channel. Disen­
gage the roller from the channel.
• Push the window rearward, then tilt it up until
the front roller is disengaged.
• Place the window in a level position, and raise it
straight up and out of the door.
M Install or Connect (Figure 30)
Door window glass
1. (100).
• Lower the window into the door frame.
• Push the window rearward, then tilt it up, and
slide the front roller into the sash channel.
• Slide the glass forward until the rear roller is in
line with the notch in the sash channel. Engage
the roller to the sash channel.
• Slide the glass forward into the glass run
channel.
• Remove any masking or covering.
2. Stationary glass/window run channel assembly.
Refer to "Stationary Glass/Window Run Channel
Assembly Replacement."
3. Door trim panel. Refer to "Door Trim Panel
Replacement."
INNER WINDOW WEATHERSTRIP
REPLACEMENT
M Remove or Disconnect (Figure 31)
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Weatherstrip from the trim panel.
• Pry the clips on the weatherstrip from the trim
panel shoulder.
B Install or Connect (Figure 31)
1. Weatherstrip to the trim panel.
• Push the weatherstrip clips onto the trim panel
shoulder.
2. Door trim panel. Refer to "Door Trim Panel
Replacement."